Pyrmont sits on the peninsula just west of the Sydney CBD, packed with converted warehouse apartments, media offices and the casino precinct around The Star. Harris St runs the spine of the suburb, with the old wool-store and woolshed buildings now homes and creative workspaces, while Union St and the light rail stops feed people down to Darling Harbour and Pyrmont Bay. It is one of the densest patches of inner Sydney, so a single block of Harris St can have a 1990s warehouse conversion next to a fresh creative-office fit-out, each needing very different wiring.
Half the boards we open in the old Harris St wool-store conversions are still ceramic-fuse units squeezed into a hallway cupboard, so a lot of our Pyrmont work starts with swapping those for RCBO switchboards before owners can add a dishwasher circuit or a heat pump. Because so many of these units are leased to media and tech staff, we get a steady run of bathroom and kitchen refit wiring between tenancies, booked around handover dates rather than weekends. The strata buildings here lean on us for common-area lighting, six-monthly exit-light testing and basement EV chargers fed off a dedicated owners-corporation meter. Around The Star and the Darling Harbour venues, our commercial side handles office and bar fit-outs, three-phase supply and after-hours fault calls when a busy trading floor loses a circuit.
A dense mix of converted warehouse and woolshed apartments along Harris St, media and tech offices through the side streets, and the casino and entertainment precinct around The Star and Darling Harbour.
The most frequent calls from Pyrmont customers cluster around:
All six DM Electrical service lines are available across Pyrmont 2009. Tap any service for full detail and pricing context.
Overhead and underground mains, point-of-attachment work, Ausgrid connections.
Switchboard upgrades, smart-meter changeovers, defect notice rectification, power reconnections.
Power out, sparking outlet, burning smell, RCD that won't reset. We answer the phone any time.
Renovations, lighting design, smoke alarms, smart-home wiring, full rewires.
Shop fit-outs, three-phase, emergency lighting, RCD testing, ongoing maintenance.
All major EV charger brands installed (Tesla, Ocular, Fronius, Wallbox, EVSE, and more), 7kW and 22kW chargers, load assessment, three-phase upgrades.
Yes. We hold strata accounts in converted warehouse buildings around Harris St and Union St, covering common-area lighting, emergency exit testing and switchboard maintenance.
Yes. We work with the owners' corporation to install a dedicated metered supply and a load-managed charger, fully compliant with AS/NZS 3000.
Yes. We handle full commercial fit-outs for the media and tech offices around Pyrmont, including three-phase supply, lighting, data, exit signs and emergency lighting.
Yes. Older warehouse conversions often have dated wiring and ceramic-fuse boards. We rewire circuits and replace the board with a modern RCBO-protected switchboard, coordinating access through strata where needed.
Yes, 24/7. We cover power failures, sparking outlets and burning smells across Pyrmont, usually on-site within about 30 minutes from Brookvale via the Harbour Tunnel.
Yes. We carry out 6-monthly emergency and exit lighting testing to AS 2293, with log books and certification for strata and commercial buildings.
Yes. We handle the full Level 2 scope including service mains, point of attachment and metering, working with Ausgrid for connections and reconnections.
About 30 minutes from our Brookvale base via the Harbour Tunnel, which keeps us close enough for both booked work and emergency callouts.
Call DM Electrical or send us a quick message. We respond fast.
Contact Us