An electrical pillar is the short metal or plastic box, usually green or grey, that sits at the front boundary of a property in an underground power area. It is where the street's underground cable connects to the cable running to your home, and it usually holds the service fuse. Most pillars belong to Ausgrid or Endeavour Energy, not the homeowner.
People also call it a pillar box, a power pillar or simply "the green box in the front yard". This guide covers what is inside one, who owns it, what to do if it is damaged, and whether you can move it or build around it.
What does an electrical pillar do?
A pillar is the connection point between the network's underground cable in the street and the consumer mains that feed your meter box. In an overhead area that job is done at the point of attachment on your house or a pole. In an underground area there is nothing overhead to attach to, so the connection sits in a pillar at ground level instead.
One pillar often serves two to four neighbouring homes, which is why it usually sits on or near a shared side boundary. Inside are the cable terminations and, for most homes, the service fuse that protects your supply. That fuse is why a fault inside the pillar can take out power to one house, or to half of it, while the rest of the street stays on. Our guide to losing power to half the house explains how a blown service fuse shows up.
Is the box in my front yard a pillar, a pit or a substation?
Size and shape tell you which network box you are looking at. All three usually belong to the network, and only the network or an authorised contractor should open them.
| Box | What it looks like | What it does |
|---|---|---|
| Pillar | Knee to waist high post or box, usually green or grey, at the front boundary | Connects the street cable to one or a few homes, holds the service fuses |
| Pit | A lid set flush with the ground or footpath | A joint or pull point for underground cables, sometimes used in place of a pillar |
| Kiosk substation | A large green cabinet, roughly the size of a garden shed | Steps high voltage down to the 230 volt supply for a whole street or block |
If the box is large, hums and carries high voltage warning signs, it is a substation, not a pillar, and the same keep-clear rules apply.
Who owns the electrical pillar on my property?
In most Sydney streets the pillar belongs to the network, Ausgrid or Endeavour Energy, even when it stands on your land. The network maintains it, repairs it and decides where it can go. Everything on your side of it, starting with the consumer mains running to your meter box, belongs to you. Our guide to submains vs consumer mains draws that line in more detail.
The exception is a private pillar. On some battle-axe blocks, shared driveways and older subdivisions, the network supply ends at the street and a privately owned pillar further in feeds several homes. The owners of those homes share responsibility for it, much like a private power pole. If you are not sure which kind you have, your network can confirm who owns the asset at your address.
What should I do if a pillar is damaged or open?
Keep clear, keep children and pets away, and report it to your network straight away. A pillar knocked over by a car, cracked by a mower, or left with its lid open can expose live parts. Do not touch it, try to close it or tape it up.
- Ausgrid areas (most of the Northern Beaches, North Shore, Eastern Suburbs and inner Sydney): call the faults and emergencies line on 13 13 88.
- Endeavour Energy areas (Western Sydney, the Hills, Blue Mountains and Illawarra): call 131 003.
- If anyone has had a shock, or there is fire or smoke, call 000 first.
The network repairs its own pillars. If the damage has also hit your consumer mains, meter box or anything on your side of the boundary, that part is a job for a private electrician, and reconnecting the mains at the pillar is Level 2 work.
Questions about the supply to your home?
DM Electrical handles underground mains, pillar connections and private pillars across the Northern Beaches, North Shore and wider Sydney. Based in Brookvale, Level 1 and Level 2 ASP accredited.
Can I build, landscape or put a fence around a pillar?
You can landscape near a pillar, but you cannot cover it, wall it in or block access to it. Network crews need to reach it to fix faults and connect or disconnect homes, sometimes at night and in a hurry. Things that commonly cause trouble:
- Retaining walls and front fences built over or tight around the pillar, so the lid cannot be lifted.
- Hedges and garden beds planted over it until nobody can find it.
- Driveways and paving poured around it so the base sits in a hole that fills with water.
- Digging next to it. The cables enter from below, so trenching beside a pillar is a real strike risk. Our guide to how deep underground power cables are buried covers safe digging.
If your plans put a wall, driveway or pool near the pillar, check the network's clearance requirements before the design is locked in, while a fence line or driveway can still shift.
Can an electrical pillar be moved?
Yes, but moving a network pillar is work on the network itself, so it needs a design, network approval and a Level 1 Accredited Service Provider. The property owner asking for the move usually pays for it. Common triggers are a new driveway crossing, a subdivision, or a pillar sitting where a new garage has to go.
The steps generally run like this: an application to the network, a design for the new position, the new pillar and cable work by a Level 1 ASP, then a Level 2 ASP reconnects the consumer mains to the new pillar. A planned outage is booked for the changeover, and any neighbours fed from the same pillar lose power for that window too. The difference between Level 1 and Level 2 electricians explains who does which part. The same process applies when an overhead street is converted underground, as on our Church Point undergrounding project.
Cost depends on the distance moved, the trenching and surface restoration, and network fees, so it is quoted per site rather than as a set price.
Who connects new consumer mains to a pillar?
Only a Level 2 ASP can connect, disconnect or reconnect your consumer mains at the pillar. That covers a consumer mains upgrade, a move from single phase to three phase supply, a new home connection in an underground area, and disconnecting a house before demolition. A licensed electrician without Level 2 accreditation can run the cable up to the pillar but cannot make the connection. DM Electrical holds Level 2 ASP and Level 1 ASP accreditation, so both sides of a pillar job can be handled by one contractor.
Frequently asked questions
Why is there a green box in my front yard?
It is almost certainly an electrical pillar. In underground power areas the street cable connects to each home's supply inside a pillar at the front boundary, and one pillar often serves two to four houses. It belongs to the network in most cases, even though it sits on your land.
Can I open my electrical pillar to check the fuse?
No. A pillar contains live parts connected straight to the street supply with no protection ahead of them. Only the network or an accredited service provider should open it. If you have lost power, check your own switchboard first, then call your network's faults line.
Who pays to repair a damaged pillar?
The network repairs its own pillars. If a driver, builder or landscaper damaged it, the network may recover the cost from them. Privately owned pillars are repaired at the cost of the owners they serve, and any damage on your side of the pillar is yours to fix.
Can I plant a hedge in front of a pillar?
Keep plants low and well clear so the pillar stays visible and the lid can be lifted. Network crews need quick access during faults, and a hidden or overgrown pillar can delay restoring power to you and your neighbours.
The bottom line
The pillar at your boundary belongs to the network in most streets, it holds the fuse for your supply, and it needs clear access at all times. Report damage to Ausgrid or Endeavour Energy, and talk to an accredited service provider before you plan anything that moves it or connects to it. If you have a project near your pillar, get in touch and we will tell you what is involved.